3.Connect the AE-Y310 unit with external heater as in the below diagram:
L N
H
L
〇
●
N
HEATER
〇
Warning!
Beware of electric Shock! Always shut down electric power before installation.
4.Slide the unit back to the panel plate. Check that the unit is firmly fixed onto the panel plate.
Installation is completed.
1.Heater Control
Switch on the unit by putting the Power switch at On position. Power LED (red) tums on. Set the rotary
volume at the temperature you deserve. When room temperature is lower than the set temperature, the
thermostat switches on the heater connected and at the same time, heat LED (green) turns on. When
room temperature becomes higher than the set temperature, the thermostat switches off the heater and
heat LED (green) tums off.
2. Unit Off
Put the Power switch at Off position. Thermostat stops running and there is no output to the heater
connected.
Product Specification:
Model
AE-Y310
Working Voltage
220VAC,50Hz
Current Rating
16Amp(Resistive)
Maximum Rating
3500W
Control Range
20℃-60℃(floor)
Temperature Accuracy
2℃
Span
1℃
Switching Type
SPST
Temp.Sensor Type
NTC sensor
Working Temp. Range
0℃～60℃
Storage Temperature
-20℃～60℃
