●
The charger will indicate charging by a red LED. A green led
will indicate completed charge.
●
Disconnect the charger, inspect the o-ring for damages and
dirt. Replace o-rings or clean them if necessary, refit the lid
and make sure it is in the locked position.
Charge without charge port
●
Open the dive light by unscrewing the sealing plastic plug
counterclockwise.
●
Disconnect the battery connector by pressing down on the
latch and pull the connectors apart (see picture).
●
Connect the charger connector to the battery connector.
It
is important that the connectors are connected to each
other in the correct orientation
(see picture).
●
Plug the charger into a wall outlet. The charger's indicator
light turns from red to green when the battery is fully
charged.
●
When the battery is fully charged, disconnect the charger
connector and reconnect the dive light connector.
It is
important that the connectors are connected to each other
in the correct orientation
(see picture).
●
Inspect the o-rings, clean any debris and replace them
immediately if damage exists.
●
Make sure that the elastics around the battery is tight and
keeps cords and plugs in place.
●
Close the dive light by pushing the plastic plug into the pipe,
past the first o-ring. Tighten the plastic cap by turning
clockwise. Be careful so that the parts threading properly
against each other.
3.2 USAGE
The drop-shaped knob controls the functionality of the lamp.
Loosening or tightening the screw can adjust wrath of inertia.
3.3 SWITCH THE LIGHT ON
●
Turn the knob clockwise. It will start at 75 %.
●
To check the battery charge status: turn the light on and
then off within 2 seconds, a number of short flashes indicate
battery charge status:
Flashes
Battery Level
4
75-100%
3
50-75%
2
25-50%
1
5-25%
