N&W Global Vending Snakky RY, Руководство по установке

Страница: 11 / 52

© by N&W GLOBAL VENDING S.p.A.
7
06 2007 294-00
As standard feature or using special kits, the machine
can be equipped with small compartments, suitable for
dispensing cans, plastic bottles up to 69 mm dia., 0.2
litre Tetra-Paks.
The compartments equipped in this way can be recog -
nised by the shape of the product support bracket (see
fig. 9).
Some bottle types can be dispensed without using the
supports.
Most bottles can be dispensed without using any special
accessories, loading the bottles up side down, so that
the cap slides in the compartment channel.
The spirals can be positioned with 22,5 degree steps by
pulling them towards the front and rotating them in the
direction of ejection.
Normally, the products can be dispensed without any
problems when the spiral end is in the lower centre posi -
tion.
From the following table and from fig. 8, knowing the
pitch and the direction of the spirals, it is possible to get
the maximum size and the number of products that can
be dispensed.
The machine is supplied with a table indicating the opti -
mum setting for the different product types. The configu -
ration can be changed following the indications in the
relevant chapter.
coNfiguRiNg thE SpiRalS
According to the size of the products to be dispensed,
each machine can be fitted with a variable number of
trays (maximum 6), of product compartments and with
dispensing spirals of different pitch.
The spirals can be housed either in 152 mm compart -
ments (two spirals, right-hand and left-hand, in each
compartment) for large size products, or into 75 mm
compartments (one right-hand spiral in each compart -
ment) for small size products.
In the 75 mm compartments (dispensing candy sticks or
similar products) it is possible to set the rotation of the
spirals to 180° instead of 360° and use a special right
hand spiral fitted with a divider (see fig. 8), doubling the
capacity of the compartment.
It is possible to insert a divider in the already installed
spirals (see fig. 8).
Fig. 8
180° rotation spiral 1-
Divider 2-
A- Spiral pitch
B- Product maximum size
a
mm
b
mm
N-°
80 76 6
64 60 7
54 50 8
46 42 9
40 36 10
34 30 11
30 26 13
24 20 15
19
24 (180°) 20 19+19
Fig. 7
Tray 1-
Movable partitions 2-
RH spiral 3-
LH spiral 4-
Fig. 9
Compartment channel 1-
Product support bracket 2-