N&W Global Vending Canto LB 3600, Установка, эксплуатация и обслуживание

Страница: 19 / 72

© by N&W GLOBAL VENDING S. p. A.
13
09 2010 H 83127 00
LaBEL INsErtIoN
to insert the product labels, disassemble the label sup-
ports after having removed the three fastening screws by
acting on the clamping tangs (see fig. 17).
Insert the labels into the slots alternatively opening on
the right and left side.
some buttons may not be used according to the models
(see the selection dose table).
the self-adhesive labels also supplied shall be applied
to the product containers according to the arrangement
(see the selection dose table).
CoNNECtIoN to tHE watEr maINs
the vending machine must be connected with the drink-
able water mains according to the provisions in force in
the country of installation of the equipment.
the mains pressure must range from 0.05 to 0.85 Mpa
(0.5 8.5 bar).
let water come out of the water mains until it is limpid
and free of any trace of dirt.
Connect the water mains with the 3/4” gas fitting of the
water inlet solenoid valve by means of a tube that can
support the mains pressure and of a type suitable for
foodstuffs (min. inner diameter 6 mm.) (see fig. 18).
It is recommended to apply a tap on the water
mains outside the machine in an accessible posi-
tion.
o
verfloW Device
The water inlet solenoid valve (see fig. 18) is complete
with an overflow device that can mechanically lock the
water inlet as a result of a malfunction of the solenoid
valve or the water level control device in the boiler.
to restore the normal operation, act as follows:
power off the machine; -
drain the water in the overflow tube; -
close the water mains tap outside the machine; -
loosen the fitting intended to fasten the supply tube -
of the solenoid valve to discharge the residual mains
pressure and tighten it again (see fig. 18);
open the tap and power on the machine -
s
ofTeNer
the machine is supplied without a softener.
If water is very hard, you can mount a softener.
softeners, available as an accessory, shall be regener-
ated according to the manufacturer’s instructions at regular
intervals.
Fig. 17
Fastening screws 1-
Clamping tangs 2-
Label support 3-
Product labels 4-
Fig. 18
3/4" gas water inlet fitting 1-
Inlet tube fitting 2-
Overflow tube 3-