Nalu User’s Kit Instructions for Use PN: MA-000007 Rev C
Page
17
of
44
Powering ON the Therapy Disc
1. Press and release the ON / OFF Program button.
2. Listen and watch.
3. The buzzer will beep and the white LED will blink to indicate battery level.
# white blinks/ beeps
Battery Level
4
Fully charged
3
¾ charged
2
½ charged
1
¼ charged
Orange
Discharged (low battery mode)
4. Following the white LED blinks, the green LED will blink to indicate the most recently used program. The
number of green LED blinks corresponds to the current program.
Connecting the Therapy Disc with the Nalu Implantable Pulse Generator
1. Place the Therapy Disc over the implant.
2. Three (3) short beeps will sound when the Therapy Disc connects to the implant.
NOTE
:
The Therapy Disc starts stimulation at the most recently used program and stimulation level.
NOTE
:
If the Therapy Disc becomes disconnected from the implanted Pulse Generator after having
been connected, the Therapy Disc will beep once every second.
3. To dismiss the alert, press and hold the Up or Down button.
4. To reactivate the alert, press and hold the Up or Down button.
Connecting the Trial Therapy Disc (For the Trial
System Only)
1. Plug the micro HDMI adapter into the micro HDMI port on the
Trial Therapy Disc as shown in Figure 1.
2. Three (3) short beeps will sound when the Trial Therapy Disc
connects to the lead.
Figure 1: Connect Trial Therapy Disc
to Electrode Interfacing Cable
