EN
WWW.NAKAYAMATOOLS.COM
2
Dilution Of Chemicals / Charging To The Chemical Tank
Caution :
Agricultural chemicals are extremely dangerous, and must be han
-
dle with care. Read the manual for specific chemical carefully before use.
Dissolve water dispersible power in a separate container before filling. Be
sure not to get foreign material into the chemicals.
Open the air bleed nozzle, and bleed until the chemical is draining out, and then close the nozzle securely. Before spraying the
agrochemical, be sure to put on suitable protective clothing to protect yourself against contact with and breathing it. Observe
the following cautions for safe operation:
a) Be sure to close the chemical tank cover securely.
b) Check the spray hose and nozzle connections to make sure there are no leakage.
c) Always stop the engine before refilling the fuel tank or changing the nozzle.
d) When carrying a full chemical tank, be careful not to lose your balance.
Starting the engine
Important :
When starting the engine, be sure to fill the chemical tank with pure water or chemical liquid. Never run the en
-
gine when the chemical tank is empty.
Pump the primer bulb until fuel can be seen flowing through the fuel return line, and pull the choke lever to full close. (During
hot weather and when the engine is already warmed up, the choke lever may be set to either half open or full open.)
Set the throttle lever to the middle speed position (not necessarily to maximum).
Pull the recoil starter lightly 2-3 times.
Pull the recoil starter strongly to start the engine.
If the engine stops after a few revolutions, set the choke to half open, and pull the recoil starter rope strongly again to restart
it. Note: If the engine does not catch even after the starter is pulled several times, set the choke lever to full open and pull the
starter rope. Be sure not to pull the starter lever completely out. After the engine starts, open the choke lever slowly, move
the throttle lever to the low-speed side, and let the sprayer warm up for 2-3 minutes.
The first starting attempt
Choke lever : Fully
Matching mark at
STARTING
Throttle lever
Middle speed position
When the engine is warm
Choke Lever: Fully Open
Close tight to seal
Chemical Tank Lid
Primer Bulb
