16
Checking the adjusting the idling speed
The cutting blades should not when the control lever is fully released.
-Idle speed should be set to 2.600rpm.
If necessary, correct it by means of the idle screw (the cutting blade
must not run when the engine is on idle).
Clockwise: for faster rate of revolution.
Counter-clockwise: for slower rate of revolution Check that
there is sufficient difference between idling and clutch
engagement speed to ensure that the cutting tool is at a
standstill while the engine is idling. (If necessary, reduce idling
speed.) if the tool still continues to run under the idling
conditions, consult your nearest authorized service agent.
The clutch should engage at minimum 3.250 rpm.
Check the functioning of the STOP switch, the lock-off lever,
the control lever, and the lock button.
Cleaning the air cleaner-Every& hours (Daily)
-Remove the dir cleaner cover.
-Push the choke lever up (arrow).To prevents dirt particles from
entering the carburetor.
-Take out the sponge element, wash it in lukewarm water and dry it
completely.
-After cleaning, put back the sponge element and air cleaner cover.
Checking the spark plug – Every 8 hours (Daily)
-Only use the supplied universal wrench to remove or to install the
spark plug.
-The gap between the two electrodes of the spark plug should be 0.6
to 0.7mm. If the gap is too wide or too narrow, adjust it. If the spark
plug is clogged with carbon or fouled, clean it thoroughly or replace
it. Use an exact replacement.
Supply of grease and lubricant
-Supply grease the gear through the grease hole every 10 to 20
hours. (Shell alvania No.3 or equivalent)
