14
c) If the blade is bent (do not align!)
d) If the gears are damaged.
Replacing and resharpening the cutting blade at the end of the mowing season always resharpen
the cutting blade or, if required, replace the cutting blade with a new one. Always have the cutting
blade resharpened or replaced by a customer service centre (measurement of imbalance).
Unbalanced blades will cause the lawn mower to vibrate violently-risk of accident !
Change and clean the spark plug
1) Once the engine has cooled, remove the spark plug using the socket spanner supplied.
2) Clean the plug with a wire brush.
3) Using a feeler gauge; set the gap to 0.6-0.7 mm.
4) Install the spark plug carefully by hand, to avoid cross-threading.
5) After the spark plug is seated, tighten with spanner to compress the washer.
Clean the air filter
Unclip the air filter cover and remove the sponge filter element. To avoid objects falling into the air
tank, replace the air filter cover. Wash the filter element in warm soap water, rinse and allow drying
naturally.
Warning!
Never run the engine without the air filter element installed.
Storing the unit
After cutting, clean the unit thoroughly. Store the unit in a dry room allow the motor to cool down
beforehand.
Troubleshooting
Before performing any maintenance or cleaning work, always turn off the engine and wait
until the cutter has come to a standstill
1) Engine does not run:
---Reassemble the blade or Nylon cutter.
---check the fuel if spend the pack.
2) Engine power drops:
---Have cutting blade resharpened /replaced (customer service centre)
3) if the temperature of machines is too high :
---insure the machines have rest at regular time.
Faults which cannot be rectified with the aid of this table may be rectified by a specialist company
only (customer service centre).
