EN
7
WWW.NAKAYAMATOOLS.COM
Storage
Warning:
During operation the muffler or catalytic muffler and surrounding cover become hot. Always keep exhaust area clear of flammable debris during
transportation or when storing, otherwise serious property damage or personal injury may result.
Long Term Storage (Over 30 Days)
Do not store your unit for a prolonged period of time (30 days or longer) without performing protective storage maintenance which includes the following:
1. Remove the chemical tank, clean the dust gate and inside the chemical inside Store unit in a dry, dust free place, out of the reach of children.
2. Store unit in a dry, dust free place, out of the reach of children.
Warning:
Do not store in enclosure where fuel fumes may accumulate or reach an open flame or spark.
3. Remove accumulation of grease, oil, dirt and debris from exterior of unit.
4. Perform all periodic lubrication and services that are required.
5. Tighten all screws and nuts.
6. Drain the fuel tank completely and pull the recoil starter handle several times to remove fuel from the carburettor.
7. Remove the spark plug and pour 7cc (1/4oz,1/2tablespoon) of fresh, clean 2-stroke engine oil into the cylinder through the spark plug hole.
a. Place a clean cloth over the spark plug hole.
b. Pull the recoil starter handle 2-3 times to distribute the oil inside the machine.
c. Observe the piston location through the spark plug hole. Pull the recoil handle slowly until the piston reaches the top of its travel and leave it there.
8. Install the spark plug (do not connect ignition cable).
9. Remove blowy pipe assembly from unit.
Troubleshooting
Problem
Cause
Remedy
Engine-starts hard
Engine-does not start
Engine
Cranks
Fuel at
Carburettor
No fuel at
carburettor
Fuel strainer clogged
Fuel line clogged
Carburettor
Clean
Clean
See your dealer
Fuel at
cylinder
No fuel at
cylinder
Carburettor
See your dealer
Muffler wet
with fuel
Fuel Mixture is too rich
Open choke
Clean/replace air filter
Adjust carburettor
See your dealer
Spark at end
of plug wire
No spark
at end of
plug wire
Stop switch off
Electrical problem
Interlock switch
Turn switch on
See your dealer
See your dealer
Spark at
plug
No spark
at plug
Spark gap incorrect
Covered with carbon
Fouled with fuel
Spark plug defective
Adjust 0.65mm
Clean or replace
Clean or replace
Replace plug
Engine
does not
crank
Internal engine problem
See your dealer
Engine
runs
Dies or accelerates poorly
Air filter dirty
Fuel filter dirty
Fuel vent plugged Spark plug
Carburettor
Cooling system plugged
Exhaust port/spark
arrestor screen plugged
Clean or replace
Replace
Replace
Clean and adjust/replace
Adjust
Clean
Clean
Engine
Runs
properly
Blower does not work,
is weak or uneven
Blower Pipe clogged,
loose or damaged
Unclog
Tighten
Replace
EN
* The manufacturer reserves the right to make minor changes to product design and technical specifications without prior notice unless these changes significantly affect the performance and safety of
the products. The parts described / illustrated in the pages of the manual that you hold in your hands may also concern other models of the manufacturer's product line with similar features and may not be
included in the product you just acquired.
* Please note that our equipment has not been designed for use in commercial, trade or industrial applications. Our warranty will be voided if the machine is used in commercial, trade or industrial businesses
or for equivalent purposes.
* To ensure the safety and reliability of the product and the warranty validity, all repair, inspection, repair or replacement work, including maintenance and special adjustments, must only be carried out by
technicians of the authorized service department of the manufacturer.
