The set screw facing
towards you and the
tip of the blade is
installed to the left.
The set screw facing
towards you and the
tip of the blade is
installed to the right.
Main power cord
Handpiece
Back of controller
Connecting the cords to back of controller
1
Optional foot switch
Setup Guide
Align each
dents and
insert the plug.
2
3
Make sure the blade has been installed correctly
Loosen the set screw and insert the blade
Tighten the blade by set screw
4
The LED on the control panel lights up.
Max output
power
3.0 W or less
If the WATT is smaller than 3.0 when the maximum output power is displayed,
the blade has been installed correctly.
3.0 W or less is only a guide line. It may be bigger or smaller depending on the
surrounding temperature and environment.
Make sure of the installed blade’s direction, whether the set screw is tight enough and
whether the blade is not damaged. If there is no improvement, replace the blade or set screw.
Loosen the set screw by supplied hexagon wrench.
Remove the cap
straight forward.
Both ends of the blade
do not touch the horn
and shows gaps.
The blade touches
the horn.
Tighten the blade in center, in a position where both
ends of the blade do not touch the horn. The standard
tightening torque is 1.5 N/m.
For easy setup tighten the
set screw lightly at first,
then make adjustments to
the blade.
See attached operation manual
for details.
②
②
①
①
Insert the no damaged blade completely into the horn.
③
③
• O ring
• Operation manual
• Fuse
2 pcs
Bundled items
• Controller
• Handpiece
• Main power cord
• Spare blades
40 pcs
• Spare set screw
4 pcs
• Hexagon wrench
2 pcs
