NAiS EP 790, Инструкция по эксплуатации

Страница: 8 / 10

-22-
What to do if ...
(something does not work)
• Has the Lounger been plugged into the mains socket?
• Has the other end of the lead been plugged into the Lounger?
• Has the switch at the rear left of the Lounger been switched on?
• Does the childproof lock prevent the Lounger being switched on?
• Has the sliding cover on the control panel engaged?
• Has the power lead been plugged into both the mains socket
and the Lounger?
• Has the switch at the rear left of the Lounger accidentally
been switched off?
• Has the required massage course button been pressed?
(The corresponding red pilot lamp lights up.)
• Has the sliding cover on the control panel engaged?
• Has the correct height been set for automatic massage
courses? – Check the setting and correct it if necessary.
• This is a safety precaution to prevent the motor overheating.
Such a stop may occur under adverse conditions when
massage starts, for instance if you have pressed heavily
against the massage heads at the very beginning. Remedy:
raise yourself slightly in the chair and start again.
• Call the customer service department if the chair cannot be
restarted and pilot lamps start flashing again.
• When a specific massage program has been set, there may
be a short delay while the massage heads first move to their
starting position before rolling/stretching massage, for
instance, begins.
• This is normal when the massage heads have reached the
upper or lower limit positions, for example, or the “strong/
gentle” or “narrow / wide” limits. Release the button and
correct the setting in the opposite direction or select the
required massage mode (see page 19, No. 3 and 4).
• You have not set the slide control (right-hand side of the
control panel) to the correct body height for you. Further
details on page 18, No. 2.
If your Massage Lounger does not work, this is often due to
minor causes which you can remedy yourself. Check the follow-
ing points/tips before you call the customer service department.
The faults listed under “What to do if ...” are due to causes which you can remedy yourself. Be sure to check this list
before contacting the service department as you may otherwise have to pay service charges, even during the warranty
period. This also applies to malfunction arising from incorrect operation.
... the Massage Lounger does not work at all
... the power indicator does not light up
... the Massage Lounger does not
massage you at all or not correctly
... massage stops and the control panel
issues a warning in flashing pilot lamps
... massage does not start immediately
... the massage heads stop when personal
massage is set
... the massage heads start too high or too
low for one of the automatic courses