4
U-41 QUAD RECEIVER
Rack-mounting the Receiver
The Nady U-41 QUAD UHF receiver has built-in brackets for rackmounting. Simply attached the
unit to the rack and tighten the unit with screws.
(Note: Do not mount the receiver in a rack directly above an amplifier or other source of high heat.
This could degrade the performance of the U-41 QUAD. Always ensure adequate airflow and heat
dissipation in any rack configuration.)
Antennas
Install antennas by connecting the two
AntennAs (1)
included with your system to the two
RF BnC ConneCtoRs (2)
located on the left and right front of the U-41 QUAD receiver.
The optimal positions of the antennas are 90 degrees from the receiver pointing up position.
For maximum range, it is always best to maintain a line of sight (no obstructions) between the
receiver antennas ant the transmitter at all time whenever possible.
Powering the Receiver
Power the receiver by plugging the provided
AC AdAPtoR (3)
(16.5VDC/0.4A) plug into the
dC InPUt jACk (4)
on the back of the receiver. Then plug the adapter into an AC outlet.
(Note: Any 16.5VDC source with 400mA capacity can also be used.)
Turn
volUme ContRols
(5)
of all channels counterclockwise to minimum settings. Once the receiver is connected to a
power source, press the
PoweR swItCh (6)
to the ON position. The
tX IndICAtoR leds (7)
on the front panel of the receivers will not light up at this time, until one or more of the four channels
is receiving a signal from your system’s transmitters.
To turn OFF, press the
PoweR swItCh (6)
to the OFF position. The receiver will be off.
Adjusting mute
In normal operation, each channel’s
mUte ContRol (8)
should be turned clockwise fully to the
factory preset RF level of 1uV for maximum sensitivity. Doing so sets each receiver for maximum
range. However, in case of high RF activity, the mute should be adjusted. If, with a transmitter
turned off, its corresponding LED on the receiver front panel flickers or stays on, the mute control
of the corresponding channel should be turned counterclockwise until the LED extinguishes.
For each of the four channels, when the mute is properly adjusted, the corresponding LED will
light only when the system’s transmitter is turned on.
Turning the mute clockwise too far will result in reduced range, but yield a quieter signal during
dropout or at the end of the operating range.
Audio level and Peak led indicator
The U-41 QUAD receiver is equipped with a 5-segment
led AF level (9)
display for each
channel. The red LED on the right of these displays is the audio peak indicator. Note that the peak
red LED will light with a strong audio signal from the transmitter. Occasional flickering of the peak
LED on loud input signals to the transmitter is normal. However, If the peak LED lights continuously,
the volume into the transmitter should be decreased or audio distortion may result.
Connecting Audio outputs
The U-41 QUAD audio output stage of each channel is configured for XLR balanced microphone
fixed level, with an output impedance of 600 ohms, to accommodate both balanced and unbalanced
mics. The
XlR oUtPUts (10)
are preset at the factory and are not adjustable with the receiver
volume controls. For each channel you wish to use, insert an audio cord with a female XLR plug
into its audio jack on the back of the receiver. Plug the other end cord into your amplifier, effects
or mixing board. The volume level of each receiver should be adjusted by the mixing board.
