Nady Systems MGT-16, Руководство пользователя

Страница: 11 / 20

The IR Sync Button (14) on the MGT-16
receiver is used to transfer the selected
frequency info from the receiver to the
transmitter for quick synchronization prior
to use. Begin programming by holding the
wireless transmitter’s
IR Receptor/Sensor
Window (21, 31, 46, 56) about 6-12”
from the receiver’s IR Synch Infrared LED
Window (1) . Press the IR Sync Button
once to begin the IR sync download of the
selected frequency to the transmitter.
Note: To insure proper synchronization, the
transmitter must always be just turned on, or
else turned off then on again, before syncing.
When the RF Signal LED (10) on the
receiver lights up, the system frequency
is properly synchronized. To change to a
different frequency, reset the
Frequency
Select DIP Switches (4) and sync the
transmitter again to the new selected
frequency first, after turning the transmitter
off and then on again. If no action is
taken during the 10 seconds of active data
transfer ( i.e., the transmitter is not turned
on or properly positioned) the receiver
and the transmitter units do not link and
transmitter’s previously programmed
channel remains unchanged.
Note: Only one transmitter can be used with
one receiver. It is not possible to use two
transmitters on the same frequency and mix
the output of these transmitters into one
wireless receiver.
Note: The IR link is infrared light and works
best when this data transfer is accomplished
in a light-shielded or darker environment. It
may not be successful in a brightly lit area.
If the transfer fails, repeat the procedure in
a darker location or somehow shield the link
from outside light to successfully program
the transmitter with the selected channel
info from the receiver.
Connecting Audio Output
The MGT-16 receiver’s Audio Output Jack
(7) is a ¼” unbalanced line out and its
level is controlled by the Volume Knob
(3) . Plug an audio cable with a ¼” mono
(tip/sleeve) plug into the audio output jack
and plug the other end into your pedal
board or amplifier/mixer as you would with
a direct cord from the instrument or mic.
When the Volume knob is set to maximum
receiver volume setting, the system audio
output is approxi4dB higher than a
direct instrument (or mic)-to-cord-to-amp
connection.
Note: As when making any connection,
make sure the amplifier volume control is
set at the minimum level before plugging
in the receiver to avoid possible speaker
damage
.
Your MGT-16 receiver is now operational
and ready to use. Once you have completed
the above steps, proceed to the following
instructions for the transmitter model
supplied with your system.
MT-16A transmitter pictured. Use
same procedure with transmitter
model supplied with your system
11