background image

11

1.  Snap open the 

BATTERY COMPARTMENT (30

) and insert a fresh 

9V BATTERY (31)

observing the correct polarity. Close the compartment. The WGT is provided 

with a 3.5 mm 

LOCKING JACK (32

) for connecting the 

INSTRUMENT CABLE (35

). 

To secure the connection, turn the metal slip ring on the plug clockwise to thread 

it on to the jack. To unplug, reverse the process. Slip the transmitter into a pocket 

or clip on to your clothes or instrument strap. 

(Note: As the cord to the instrument 

also serves as the antenna, be sure to extend it fully for maximum range. 

Rolling up or shortening the cord may reduce the effective operating range.) 

2.  Turn on the WGT by sliding the 

OFF/STANDBY/ON SWITCH (32

) to the STANDBY 

position (transmitter on, audio muted) or the ON position (transmitter and audio 

both on). The 

BATTERY INDICATOR LED (33

) will give a single quick flash, indicating 

usable battery strength. In the case of a dead or low battery, the LED either will 

not go on at all or will stay on continuously, indicating that the battery should be 

replaced with a fresh one.

3.  The WGT transmitter is now ready to use.  The A and/or B 

DIVERSITY LED 

INDICATORS (3) 

and most or all of the 

RF DISPLAY LEDs (4)

 on the Encore II receiver 

should now be lit, indicating a received signal from the transmitter. Adjust the 

volume of the receiver as per the Audio Output Instrument Connections section of 

the above Encore II receiver instructions. For optimum performance, an 

INPUT 

LEVEL CONTROL (34)

 is provided on the top panel of the WGT. Adjust the gain by 

turning the control with a small slot head screwdriver. It is recommended that this 

control be turned to maximum gain. However, for ultra high‑gain instrument 

sources such as active bass pickups or even extra hot guitar pickups, turning the 

level down slightly will create a cleaner sound. 

(Note: Turning down the input gain too much can compromise the signal-to-noise 

ratio and is not recommended. Set for the maximum possible gain and headroom 

without noticeable distortion on the high level peaks).

  The 

AF LEVEL LED DISPLAY (5)

 on the Encore II receiver will light up to 5 LEDs (4 

green and 1 red) for all input signals. Occasional flickering on and off during 

use of the top red LED indicator in this display is normal, however if the red LED 

stays on continuously, turn down the instrument volume or adjust the

 INPUT LEVEL 

CONTROL (34) 

on the WGT transmitter, or noticeable distortion may result. 

 

(Note: Scratchy noises can sometimes occur when some electric guitars/basses 

with dirty pots or connections are used with any wireless system. For this reason, 

the supplied 

INSTRUMENT CORD (35)

 has a factory installed capacitor inside 

the 1/4" plug. This capacitor provides first order filtering of the RF signal from 

the cord into the guitar and eliminates virtually all scratchy noises. Should your 

equipment still give you scratchy noises, we suggest these steps to eliminate them: 

 

1)  Make sure all guitar volume and tone pots are clean and all contacts 

 

are solid—this is very important. 

 

2)  Provide extra filtering with a 220 pF capacitor soldered across the 

 

hot to ground terminals of the guitar's volume and tone pots.)

WGT INSTRUMENT BODYPACK TRANSMITTER

Содержание DigiTRU Diversity ENCORE II

















Отзывы: