FRONT PANEL
Note: 1 through 6 below are referenced to Channel 1. The other 3 Channels are identical.
1.
LINE INPUT
1/4" (6.3mm) jack for a mono signal line level input
2.
CHANNEL VOLUME CONTROL
Adjusts the channel output level
3.
TREBLE CONTROL
Adjusts the amount of treble in the signal with cut/boost range of -/+15 dB
4.
BASS CONTROL
Adjusts the amount of bass in the signal with cut/boost range of -/+ 15 dB
5.
MIC INPUT
Balanced XLR input jack [Pin 1 = Ground, Pin 2 = Hot (+), Pin 3 Cold (-)].
6.
ECHO LEVEL CONTROL
Controls the amount of echo/reverb in the channel signal
7.
MASTER VOLUME CONTROL
Adjusts the level of the master signal. If the Send/Return effects loop is connected to an external effects
device, that unit's level controls will determine the final volume [see also RETURN JACK (15) below]
8.
POWER SWITCH
Turns the unit ON or OFF. Always turn level controls down before turning on the unit.
9.
POWER ON LED INDICATOR
Indicates when the amplifier is ON.
10. CD/ TAPE VOLUME CONTROL
Adjusts the level of the signal input to the stereo CD/TAPE RCA jacks (17) in the output master signal.
11. ECHO VOLUME CONTROL
Adjusts the level of the digital echo effects volume in the output master signal.
12. DEPTH CONTROL
Adjusts the amount of depth in the echo signal. Turning this control clockwise changes the echo/reverb
effect in a manner similar to increasing the size of a room in which you are getting natural echo/reverb.
Experiment to find desired effect.
13. REPEAT CONTROL
Adjusts the length and number of repeats in the echo signal. At "0" you will get a single echo with depth
determined by the setting of the Depth control (12). As you adjust the control clockwise toward "10", you
will get an increasing number of repeats for a longer time and also the interval between repeats will widen.
Experiment to find desired effect.
Controls & Connections
DIGITAL ECHO EFFECT
ECHO LEVEL
ECHO LEVEL
ECHO LEVEL
ECHO LEVEL
ECHO VOL
REPEAT
3
6
4
11
12
13
10
7
8
1
5
2
9
4
