Nady Audio FS-4N, Руководство пользователя

Страница: 6 / 9

REAR PANEL
6. BALANCED SIGNAL INPUT JACK (1/4" TRS)
This 1/4" TRS (Tip/Ring/Sleeve) phone jack is wired for balanced input signals (0.775V=0dBm, 15K Ohms)
and signal polarity is Tip = Cold (+), Ring = Hot (-), and Sleeve = Ground.
7. BALANCED SIGNAL OUTPUT JACK (1/4" TRS)
This 1/4" TRS jack provides a balanced signal output (600 Ohms) and is wired with the same signal polarity
as the Input Jack above.
8. 24 VDC TERMINAL
Use this screw terminal to operate the unit with external 24 VDC powering, either from a power supply or a
battery. Observe the correct polarity (+ and -) when making connections as marked on the terminal. The power
requirement is 250 mA.
9. AC FUSE HOLDERS
This fuse holder contains an AC primary fuse. When this fuse blows, replace it with the same type fuse, size
and power rating (120 VAC: 0.315A/250V; 230 VAC: 0.2A/250V). If it continuously blows, stop replacing
the fuse and refer servicing to qualified personnel.
CAUTION: After checking the AC supply voltage, be sure that the correct fuse is in the fuse holder.
10. POWER CONNECTOR
The IEC cord connector is used to connect the AC power source to your power amplifier.
CAUTION: DO NOT REMOVE THE CENTER GROUNDING PIN.
11. AC VOLTAGE SELECTOR SWITCH
Before plugging in the power cord, check to see that the unit is set for the proper voltage for your area:
~115V (60Hz) or ~230V (50Hz).
6
9 7 6
10
11
8