Nado O10, Инструкция по эксплуатации

Страница: 15 / 30

Installation from 9 kg up to 18 kg (76-105cm):
1a. Slide the Iso fi x anchors (11) to their maximum length by turning
the lever (13) . Do this on both sides of the seat.
1b. Open the cover (4) and take the top tether connector out (14) .
1c. Connect the Iso fi x anchors until you hear them click into place. The
display window on the button (12) will turn from red to green.
1d. Push the seat as far back as possible. Make sure that both Iso
fi
x
are in the same position once you have pushed
the seat back.
1e. Connect the Top Tether in the anchor point inten-
ded for this in the vehicle marked with the symbol:
1f. Lastly, tighten the strap of the TT system until the green signal is
displayed on the indicator. The strap should go over the backrest of
the vehicle seat. If necessary raise the headrest or remove it to enable
correct installation.
The ISOFIX visual indicators show whether the connector is open or clo-
sed. The connector may be closed without being secured in the ISOFIX
anchor. Please make sure that the connectors are correctly fastened into
the anchor points of the vehicle by pulling the seat once it has been
installed.
To detach the seat follow the same steps in reverse:
1g. Move the button (12) to open the connector and release the
anchors.
Installation from 15 kg up to 36 kg (105-135cm):
Follow the same steps as before,
, and . In this case you 1a, 1b, 1c 1d
should not connect the Top Tether.
There is also the possibility of installing the child seat only with the
car seat belt.
15