CONDITION
POSSIBLE CAUSES
POSSIBLE SOLUTIONS
No power.
• The power cord is disconnected.
• Plug the power cord into the wall outlet
securely.
• CI 940 at standby mode.
• Press the front panel STANDBY button to
switch ON the CI 940. (+12V TRIGGER IN/INPUT
SENSE switch set to OFF position)
• Rear panel POWER switch not at ON setting.
• Set the rear panel POWER switch to ON
setting.
CI 940 always at standby mode; cannot be
switched ON using the front panel STANDBY
button.
• +12V TRIGGER IN/INPUT SENSE switch set to
“AUTO” position.
• Slide the +12V TRIGGER IN/INPUT SENSE
switch to “OFF” position.
• The CI 940 is not powered OFF using the front
panel STANDBY button.
• Power ON the CI 940 in the same manner it
was deactivated.
No sound.
• Power AC lead unplugged or power not
switched ON.
• Check if AC lead is plugged-in and POWER
switched ON (along with the corresponding
ATO logic configuration).
• No input signal applied through the rear panel
ZONE 1 INPUT or ZONE 2 INPUT terminals.
• Check that there is active input signal applied
through the rear panel ZONE 1 INPUT or ZONE
2 INPUT terminals.
No sound one channel.
• Speaker not properly connected or damaged.
• Check connections and speakers.
• Input lead disconnected or damaged.
• Check leads and connections.
Weak bass/diffused stereo image.
• Speakers wired out of phase.
• Check connections to all speakers in the
system.
REFERENCE
TROUBLESHOOTING
10
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ