1 STANDBY BUTTON:
Press this button to switch ON the C 275BEE.
The Standby LED indicator will turn from amber to blue. Pressing the
STANDBY button again turns the unit back to standby mode.
IMPORTANT NOTICE
The rear panel POWER switch must be in the ON position for the
STANDBY button to activate.
2 STANDBY LED:
This indicator will light up amber when the C 275BEE
is in standby state. When the C 275BEE is at ON state, this indicator will
illuminate blue.
In cases of serious abuse of the C 275BEE, such as excessively low
loudspeaker impedance and short circuit, the C 275BEE will engage its
Protection circuitry, indicated by the Standby LED turning from blue to
red and the sound being muted.
In such a case, turn the C 275BEE OFF by the rear panel POWER switch,
wait for it to cool down and/or check the speaker connections, making
sure the overall loudspeaker impedance doesn’t go below 4 ohms or
8 ohms in Bridge mode. Once the cause for the protection circuitry to
engage has been removed, switch ON the rear POWER button and the
Standby Button to resume normal operation.
3 BRIDGE MODE INDICATOR:
This BRIDGE MODE indicator lights up
blue when the C 275BEE is switched to Bridge Mode. Refer also to the
item below about BRIDGE MODE at the IDENTIFICATION OF CONTROLS
– REAR PANEL.
4 SOFT CLIPPING INDICATOR:
The blue SOFT CLIPPING LED shows
that the SOFT CLIPPING mode is engaged. Refer also to the item below
about SOFT CLIPPING at the IDENTIFICATION OF CONTROLS – REAR
PANEL.
IDENTIFICATION OF CONTROLS
FRONT PANEL
1
2
3
4
6
ENGLISH
FR
ANÇ
AIS
ESP
AÑOL
IT
ALIANO
DEUT
SCH
NEDERL
ANDS
SVENSK
A
РУ
ССКИЙ
