6
Deep brushing
Light brushing
Storage position (after work)
6. To spray water, rotate backwards the RIGHT handle.
7. Pull back the machine. In this way you will clean a stripe of carpet by spraying, brushing and
vacuuming it in the same time.
8. After cleaning a complete stripe, stop spraying and proceed few more centimeters backwards, to
completely dry the stripe.
9. To put the machine at the beginning of the next stripe, bend the machine backwards, raising the
vacuum head, and push forward the machine.
10. Let the vacuum head touch again the carpet,
ATTENTION:
The brush motor is protected from overload, by a protection located on the control panel. If this
protection intervenes, it is necessary to reduce the pressure of the brush, to avoid the overload of the
motor. If this is not enough to avoid that the protection repeatedly intervenes, you should contact the
technical assistance. The repeated intervening of the protection might result in faults which cannot be
covered by warranty.
Keep an adequate safety distance from other people, who could be run over by the machine. Pay
attention to any object that could be hit by the machine. Never leave the machine unguarded.
Do not let the pump function without water! This could cause a damage of the pump.
The machine should not be used to vacuum dust, which would be sucked by the vacuum motor,
damaging it.
Verify that the brush inserted in the machine is the appropriate type for the surface to be cleaned. In
particular, the optional specific brush for hard floor should not be used on carpet, since it might be too
aggressive for carpet and damage it, or it could cause an overload of the brush motor.
