English
- 7 -
4. Settings
You can manage the settings of your TV using the
options of this menu. Refer to
Settings Menu Content
section for more information.
You can reset your customisations on the
Home
menu
to defaults using the
Reset Apps
option (availability
depends on TV model and its features). Highlight and
press
OK
. A confirmation message will be displayed.
Highlight
Yes
and press
OK
to proceed. Note that you
will not be able to perform this operation again within
the next few minutes.
5.
Sources
You can manage your input source preferences using
the options of this menu. To change the current source
highlight one of the options and press
OK
.
5.1.
Source Settings
You can access the source settings menu directly using
this option.
Edit the names, enable or disable selected
source options.
Inserting the Batteries into the Remote
Remove the screw that secure the battery compart-
ment cover on the back side of the remote control
first. Insert two size
AAA
batteries. Make sure the (+)
and (-) signs match (observe correct polarity). Do not
mix old and new batteries. Replace only with same or
equivalent type. Place the cover back on. Then screw
the cover back on again.
Note that when the batteries are low, the performance
of the remote control may be impaired and the LED
indicator on the remote may not illuminate when a
button is pressed.
A message will be displayed on the screen when the
batteries are low and must be replaced.
Batteries should not be exposed to excessive heat
such as sunshine, fire or the like.
Power Connection
IMPORTANT
: The TV set is designed to operate on
a
12 V DC
supply. For this, an adaptor is used which
gives
12 V
voltage. Connect this adaptor to a system
that supplies
100-240V AC, 50/60Hz
.
After unpacking, allow the TV set to reach the ambient
room temperature before you connect the set to the
mains.
2
1
1.
AC adaptor
2.
Power Input, DC 12 V terminal
Important safety information
Be sure to ground the connection
properly
Connect the ground terminal of the AC
adaptor with the ground terminal provided at
the power outlet using the enclosed power
cord. If the provided plug does not fit your
outlet, consult an electrician for replacement
of the obsolete outlet.
Surely connect the ground wire.
Antenna Connection
Connect the aerial or cable TV plug to the aerial input
(ANT) socket or satellite plug to the satellite input (LNB)
socket located on the rear side of the TV.
Rear side of the TV
1
2
LNB
ANT
1.
Satellite
2.
Aerial or cable
If you want to connect a device to the TV, make
sure that both the TV and the device are turned off
before making any connection. After the connection
is done, you can turn on the units and use them.
