12
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
Note: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there is
no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and
receiver.
- Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV
technician for help.
ISED compliance information
This device contains license-exempt
transmitter(s)/receiver(s) that comply with Innovation,
Science and Economic Development Canada’s license-
exempt RSS(s). Operation is subject to the following two
conditions:
(1) This device may not cause interference.
(2)This device must accept any interference, including
interference that may cause undesired operation of the
device.
Changes or modifications not expressly approved by the
party responsible for compliance could void the user’s
authority to operate the equipment.
L’émetteur/récepteur exempt de licence contenu dans le
présent appareil est conforme aux CNR d’Innovation,
Sciences et Développement économique Canada
applicables aux appareils radio exempts de licence.
L’exploitation est autorisée aux deux conditions
suivantes:
1) L’appareil ne doit pas produire de brouillage;
2)L’appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d’en
compromettre le fonctionnement.
Tout changement ou toute modification effectués par
l’utilisateur et dont la conformité n’est pas expressément
approvée par l’organisme responsable de sa conformité
peut entraîner l’annulation de droit de cet utilisateur de
se servir de l’équipment.
IC Radiation Exposure Statement:
This EUT is compliance with SAR for general
population/uncontrolled exposure limits in IC RSS-102
and had been tested in accordance with the measurement
methods and procedures specified in IEEE 1528.
REMARQUE IMPORTANTE
Déclaration IC d'exposition aux radiations Ce EUT est
conforme avec SAR pour la population générale / limites
d'exposition non contrôlée à IC RSS-102 et a été testé en
conformité avec les méthodes de mesure et procédures
spécifiées dans la norme IEEE 1528.
©Naava Group Oy 14.04.2021
Version 1.9.1
Содержание Duo N100x210
Страница 1: ......
