CUTOFF
Cutoff frequency
RESONANCE
Set strength of resonanse. this value can be select as 7 steps value.
AMT
Set amount of filter-cutoff envelope.
DCY
Modify decay time of filter-cutoff envelope.
LFO
●It gives fluctuations to various parameters at a relatively low frequency.
DEST
Select destination of LFO.
・CUTOFF : Filter cutoff frequency
・OSC-PTCH : Frequency of main oscillator
・MOD-DEPTH : Modulation depth of main oscillator
・MOD-PITCH : Frequency of sub-oscillator(MODULATOR)
WAVE
Choose waveform of LFO.
SPEED
Set modulation rate of LFO.
DEPTH
Set amplitude of LFO.
６．Saving and Loading Program
●Temporary Save
The sound parameters under operation will be lost instantly when you turn off the power
because this machine is not equipped with a battery. When you perform the temporary
save operation, the temporarily saved data is autoloaded at startup and can continue
work even after rebooting.
Operation
１．Push [PROGRAM] button
２． Move the cursor to [Temporary Save] using [ENTRY] knob
３．Push [ENTER] button
●Store
Up to 128 tones can be stored in the internal memory of this machine.
When received a program change message, the stored tone data is loaded.
Operation
１．Push [PROGRAM] button
２．Move the cursor to [Store Program] with [ENTRY] knob
３．Push [ENTER] button
４．Choose target channel using [Trigger Button]
５． Select program number to write data with [ENTRY] knob
６．push [ENTER] button, then program will be saved to internal memory.
●Load
Load program data from internal memory
Operation
１．push [PROGRAM] button
２．Move the cursor to [Load Program] with [ENTRY] button
３．Push [ENTER] button
４．Choose target channel using [Trigger Button]
５．Select program number to load data with [ENTRY] knob
６．push [ENTER] button, then program will be load to choosed channel.
７．Push [EXIT] button
[ATK/HLD/SLP/REL envelope]
ATTACK
HOLD
RELEASE
SLOPE
ATK (ATTACK)
The time taken for initial run-up of level
from nil to peak.
HLD (HOLD)
Sets the absolute time to hold the
maximum value of the output.
SLP (SLOPE)
When larger than 0, The output value
decays during the hold time.
REL (RELEASE)
Sets the release time. It means
weakness of attenuation after hold time.
