NA-DE V-BUS7, Руководство по установке

Страница: 80 / 132

Flat door
doorbell
button
Int Bell
D2
D1
A2
A1
V2
+
V1
-
A2 Int Bell D1 D2 A1 V2 V1
- +
Flat Door Button Connection
NVM-800MC MONITOR
MOUNTING
First connect two cables numbered as “ 1” and “ 2 ”on the backside of handsfree to connector
numbered as “ 1’ ” and “2’ “ on the wall mounting apparatus as shown in FIGURE - 1.32
Stabilize handsfree’s wall mounting apparatus to the wall from the mounting
holes with pegs and screws that are given you with the product, as indicated in
FIGURE -1.31 after you have run system cables from the holes in the middle of
apparatus
To fix handsfree to wall mount apparatus, please follow the directions below (as
shown in FIGURE - 1.33)
First, fix the handsfree’s mouting hole numbered as “ 1 “ to wall mount apparatus
notch numbered as “1”. Slide up the handsfree slightly and push to fix the other
mounting holes on the handsfree to other nocthes numbered as “2” and “3” on
the wall mount apparatus. Then screw on from the screw holes at bottom of the
handsfree as shown in FIGURE - 1.33
NOTE: Bell button must be connected between the “ Int Bell” and “GND”
connectors.
FIGURE - 1.31
(+) : +24V
(-)
: GND
(V1) : VIDEO_1
(V2) : VIDEO_2
(A1) : AUDIO_1
(A2) : AUDIO_2
(D1) : DATA_1
(D2) : DATA_2
(Int Bell) : Bell button
FIGURE - 1.30
1
Wall Mounting Apparatus
Connection Terminal Blocks
2 345 67 89
1 23456 78
1’
2’
1
2
FIGURE - 1.32
FIGURE - 1.33
1’
3’
2’
2
3
1
1 2 3 4
ON
1 2 3 4 5 6 7 8
ON
1 2 3 4
ON
1 2 3 4 5 6 7 8
ON
9
ON
12
3
4
5
6
7
8
12
3
4
ON
+24V
GND
V1
V2
A1
A2
D1
D2
INT BELL
GND
1. ID Swicth
2. ID Swicth
Ending
resistance setting
+12V GND Video-in
ON OFF
FIGURE - 1.35
1
2
3
Fix the metal mounting apparatus to the wall with two pegs and screws that is included in the product packing (as shown in Figure-1.35). After that,
connect the system cable to the terminals which is at the back of NVM-350MC product. Firstly place the "2" and "3" numbered back stops to below
of the mounting apparatus in order to fit NVM-350MC product to metal mounting apparatus. Then, by pushing product from upper part to wall, place
"number 1" spring tab on to the mounting apparatus. If it is necessary to detach monitor, put out the product by pulling "1" spring tab to upwards
with the screwdriver as shown in Figure-1.36.
FIGURE - 1.36
MOUNTING
NVM-350MC MONITOR
FIGURE - 1.34
Flat door camera connection