EN
28
by pressing the “
” key for 5 seconds. By doing so, the system will not attempt to connect to the last
connected channel every time a word is spoken out loud.
The temporary disabling of the VOX function is then removed the first time the N-Com device is
turned off; so, if the VOX Intercom is enabled (from PC or APP), it will be restored the next time the
device is switched on.
N.B.: The VOX Intercom function can be used EXCLUSIVELY with “900” series N-Com systems.
16.4.
Smart Conference (Group Intercom)
Thanks to the “Smart Conference” function, you can start the conference communication between N-
Com intercom systems of the “900” series previously paired up and saved in the 3 available channels.
All systems must be turned on and available within the connection range.
1.
Each system must have been previously paired up to all the other systems: B, C and D.
2.
Any system can press the “n” key for 2 seconds to activate the Group Conference or to start
a conference communication between all the systems.
3.
In the case where one of the systems presses the “n” key or falls outside the connection
range, the group intercom is interrupted.
Smart Conference
connection
Press the “n” key for 2 seconds. Activation is confirmed by a beep in the
helmet and by the voice message “
Group Intercom”.
Smart Conference
disconnection
Briefly press the “n” key. Disconnection is confirmed by the voice
announcement “
Group Intercom terminated”.
N.B.: During a “Smart Conference” call, connection to the mobile phones of all participants is
temporarily cut off. When the conference call ends, all phones automatically reconnect to their own
intercom system.
Note: The “Smart Conference” mode can be used EXCLUSIVELY with “900” series N-Com systems”.
Note: The “Smart Conference” mode CANNOT be used with systems paired up in Universal Intercom
mode (chapter 17).