UF-7B Rev B
13
TROUBLE SHOOTING
Q: Power cables are connected but lights aren’t turning on.
A: First, double check your power cables and make sure orientations at the radio and UF7B are correct.
If still not working press the mode button, you may be in Mode 0 (ALL OFF). If you are in a mode that
uses 2 Y-cables, make sure both of them are plugged in the correct orientation.
Q: My controller was working fine but suddenly it stopped working.
A: Double check your power cables and make sure orientations at the radio and UF7B are correct. This
is a common problem and most likely it’s plugged into UF7B backwards. If you are in a mode that
uses 2 Y-cables, make sure both of them are plugged in the correct orientation
Q: When I drive straight the turn signal is on.
A: You must adjust your steering linkage. You may have trimmed the steering to make the car go
straight, but your linkage is the problem here. Readjust linkage, then re-trim your radio then the turn
signal should shut off.
Q: My controller is working fine except the switched function (turn signals, brake lights, aircraft
landing lights, or police flashers) are not switching on/off.
A: Be sure your Y-Cable is plugged into the correct port on your radio.
For additional trouble shooting visit www.MyTrickRC.com and select the SUPPORT tab.
MODE 13 Trailer
PORT
1 or 2
ON
AUXILIARY
POWER OUT
Connect to
Vehicle Radio
(Motor Channel)
Connect
to Motor
ON
PORT
1
Connect to switchable
channel on
Vehicle Radio
(Aux Channel)
Open
(Not connected)
PORT
2
ON
DIM
ON
Arrow A
Arrow B
ON
ON
Tail/Brake
(brake
light also turns on
when in reverse
Arrow C
CHNL 1
Motor
CHNL 2
Steering
Note:
1. ON/OFF
control at Ports D, E, F, and Pigtail.
2. ON/OFF
function on 3rd Channel (including Pig Tail)
AUXILIARY
POWER OUT
Arrow A
Arrow B
Arrow C
Содержание UF7B
Страница 14: ......
