MyTek SS-1200AV, Руководство пользователя

Страница: 5 / 16

SS-1200 Rev. A OWNER’S MANUAL
5
MYTEK AMERICA

1 Chirp
1 Chirp
1 Light
Flash
Press #1
3.2 Remote System Disarm (Off)
1. Press and release the transmitter button #1.
2. Two siren chirps and two light flashes verity this operation.
3. Door will unlock (If optional keyless entry is installed).
4. Interior Light will turn on for 30 seconds (If optional Entry Illumination is installed)
5. No LED theft warning light is seen.
6. LED is active as test signal for sensors.
2 Chirps
2 Chirps
2 Light
Flashes
Press #1
Note: If you hear three chirp sounds, the system has been triggered and the alarm was activated while you were
away from the vehicle. Please refer to following chart. This diagnostic report will turn off when ignition
switch is turned on.
Diagnostic Report Audible - Chirp Visual - LED
Shock Sensor 3 chirps Double Flashes
Door, Hood or Brake Input Trigger 3 chirps Rapid Flashes
3.3 Emergency Disarm with a Secrete Key (If you lost a remote and can not shut off the alarm system)
1. With your vehicle key in the key cylinder, turn it on. (On means driving position)
2. Press and release the programming switch (Secrete Key #1, between 1 to 9) times. Programming switch is
located on the antenna.
3. Turn off the ignition then back on again.
4. Press and release the programming switch (Secrete Key #2, between 1 to 9) times. Programming switch is
located on the antenna.
5. Turn off the ignition.
6. If your secrete key is correct, the system will disarm immediately.
EXAMPLE: Secrete Key is 86.
1. When the alarm is triggered, insert the key in key cylinder then turn it on.
2. Press and release the programming switch 8 times.
3. Turn off the ignition then back on again.
4. Press and release the programming switch 6 times.
5. Turn off the ignition. You’ll hear two chirp sounds and the system will disarm.
2 Chirps 2 Light
Flashes Turn Ignition
On
Turn Ignition
Off
Turn Ignition
Off then On
Press PRS
Key#1 Times
Press PRS
Key#2 Times
3.4 Personal Protection Alarm (EMERGENCY PANIC)
1. Press and hold down the transmitter button #1 for approximately three seconds.
2. Personal Panic alarm is activated and siren sounds and lights flash for three (3) minutes.
3. Press and release the transmitter button #1 to cancel the panic alarm.