Mytee 8070 Lite, Руководство пользователя

Страница: 12 / 16

12
3 - Machine Maintenance
In order to keep the Mytee Lite™ running smoothly and
reduce the risk of damage to the machine and subsequent
downtime, Mytee recommends following the maintenance
schedule below:
Maintenance Item Daily Weekly
Clean and inspect tanks. X
Clean and inspect hoses. X
Check and clean internal filters.
X
Check power supply cable.
X
Clean machine with all-purpose
cleaner and cloth.
X
Check spray nozzles. X
Flush solution system with Mytee
System Maintainer.
X
Inspect vacuum hoses for holes and
loose cuffs.
X
Inspect spray pattern for clogging.
If clogged, remove spray tips and
soak them in a recommended liquid
neutralizer for up to six hours. To re-
move spray tip, twist spray tip body
counter-clockwise.
X
Lubricate wheels with water resis-
tant oil.
X
Inspect machine for water leaks and
loose hardware.
X
3.1 - Filter Maintenance
The Mytee Lite™ has a small filter on the top of the vac-
uum stack in the recovery tank. This filter should be
checked and cleaned after each use.
♦
3.2 - System Maintainer
Regular flushing of the solution system with Mytee Sys-
tem Maintainer keeps your extractor running efficiently by
removing hard water scaling that builds up in the system.
How to use System Maintainer:
1. Thoroughly mix System Maintainer with warm water at a
1:1 ratio in a separate container. Pour into your Extractor’s
solution tank.
2. Connect a cleaning tool (upholstery tool, wand, etc.) and
remove the jet(s) in order to prevent clogging from dis-
lodged mineral build-up.
3. Turn on the Extractor’s pump and run the System Main-
tainer solution through the system and into a bucket or
receptacle until you have a solid stream.
4. Let sit for about 5 minutes while the System Maintainer
solution does its job inside your Extractor.
5. Finish running the rest of the solution through the sys-
tem.
6. Run clean water through the system to flush out any
remaining System Maintainer.
♦
Do not tamper with the set screw on the
pump pressure switch. This can damage the
pressure switch.