Page 13
C-INSTALLING COVER
Roof Cover Installation
NOTE: DO NOT install the cover onto the frame of your building in high wind conditions. A slight
breeze is the most advantageous for cover installation. To take advantage of the breeze, pull the
cover up over the arches with the breeze blowing in the cover like a sail filled with air.
1. Roll out the roof cover on a ground sheet. Align the cover evenly to each end of the frame. Be
sure doing not over pull the end of roof cover.
2. Pull the roof cover over frame EVENLY, CAREFULLY AND SLOWLY. Insert tension tube
(No.14) into the pipe pockets. Cut a small opening over against every base plate. Put the nylon
band (No.30) around tension tube and go through winch on base plate and loosely secure. DO
NOT TIGHTEN. Adjust the cover so that it is square and evenly centered on the frame.
Note: The end flaps must overhang evenly at both ends.
3. Use ropes (No.28) to be fixed to the ends of roof cover to the front wall arches and back wall
arches.
4. When roof cover is tidy and ready, drive the winch tie down forth and back and then roof cover
is tightened in the vertical direction.
5. Tidy the cover. Pull the strap from the the ends of roof cover, make the cover well fold to end
arches and fasten the strap with winch fixed to the base plate.
