Myray 708G, Руководство оператора

Страница: 62 / 1174

EN OPERATOR'S MANUAL
61
10. ERROR MESSAGES
Code Message Description/Solution
WARNING
W 0.1 X-ray button released during
exposure.
Hold down the X-ray emission button
until the end of the procedure.
W 0.2 X-ray button not released at the end
of the examination.
1) X-ray button pressed for too
long, after the end of the
exposure (>15s).
2) Reset command output when X-
ray button was pressed.
3) The device remained in standby
mode when X-ray button was
pressed.
W 0.3 Emergency button pressed. Release the emergency button.
W 0.5 POWER electronic card can not
communicate with Logic card.
Turn off the device, wait for 30
seconds and turn it on again. If the
error persists, check the error code
documentation.
W 0.7 Active interlock. The door has been
opened with the examination in
progress.
Close the door and, if necessary,
repeat the examination.
W 0.8 Demo mode: examination not
loaded.
Demo started without loading the
examination: check connection with
the PC. Repeat the operation.
W 0.9 The unit is not set up. If the error persists, check the error
code documentation.
W 0.10 The unit is not calibrated. If the error persists, check the error
code documentation.
W 0.13 Button pressed on the keyboard
upon turning on or wake-up after
standby.
Check the keyboard. If the error
persists, check the error code
documentation.
W 0.14 Unit temperature too high. Temperature of converter card too
high, it is not possible to start a new
examination. Wait for cooling.
W 0.15 X-ray generator temperature too
high.
Temperature of X-ray generator too
high, it is not possible to start a new
examination. Wait for cooling.
Code Message Description/Solution
LOGIC PANEL ERRORS
E X.X Internal error If the error persists, check the error
code documentation.