Mylex PCI Disk Array Controller Drivers 08P4100, Инструкция по установке и эксплуатации

Страница: 29 / 100

Windows NT
Manual No. 775079 3-5
3
W
I
N
N
T
Installing the Mylex Disk Array Controller into an
Existing Windows NT 4.0 System
If Windows NT 4.0 is already installed and you wish to add a Mylex Disk
Array Controller later, the controller will be a secondary (non-bootable)
controller. After installing the controller hardware and configuring a disk
array, follow the procedure below to add the necessary controller drivers.
1. Make sure Windows NT 4.0 is up and running.
2. Click Start, and select Settings->Control Panel within the Start menu
(Figure 3-1).
Figure 3-1. Open the Windows NT 4.0 Control Panel
3. From the Control Panel window, double-click the SCSI Adapters icon
(Figure 3-2).