Mylex PCI Disk Array Controller Drivers 08P4100, Инструкция по установке и эксплуатации

Страница: 68 / 100

Installing Mylex Disk Array Controller Tape Drivers
5-8 PCI Disk Array Controller Drivers Manual
The tape drive may be placed on any channel. However, if another device
with the same SCSI ID is present on a lower channel, the tape may not
function properly.
Mylex Disk Array Controller CD-ROM Drivers
The driver that provides support for CD-ROM devices also gets installed as
a part of the standard controller SCO UNIX driver installation. It is
recommended that a CD-ROM drive installed on any controller channel be
set to SCSI ID 5.
Use the View/Update Configuration option of the Mylex Disk Array
Controller Configuration Utility to configure the CD-ROM. Save the new
configuration before trying to use the CD-ROM under SCO UNIX.
To install UNIX from a CD-ROM drive, follow the standard SCO UNIX
OpenServer installation instructions for CD-ROM. A screen will prompt you
for the type of installation being performed. You can choose either TAPE
(default), or CD-ROM, etc. From here you can select the SCSI option as
described in the SCO UNIX documentation.
If UNIX was not installed from CD-ROM, then a CD-ROM drive may be
configured using the
mkdev cdrom command. The LUN of this device should
always be set to 0.
A CD-ROM drive may be placed on any channel. However, if another non-
disk device with the same ID is present on a lower channel, only the non-
disk device on the lower channel will be accessible.