Mylex eXtremeRAID, Быстрое руководство по установке

Страница: 8 / 30

Performing an Installation
2 eXtremeRAID DAC1164P Quick Installation Guide
Figure 1. eXtremeRAID with Component Locations
Installing the eXtremeRAID into the System Board
1. With the power off, plug the eXtremeRAID card into an available 32-
bit or 64-bit PCI slot (refer to Figure 2).
Table 1. Jumper and Connector Descriptions
Jumper Description Default Setting
JP1 serial port connector –
JP2 pins 1–2 for Arm Proc, pins 2–3 for I
2
O 1–2
JP3 pins 1–2 normal , pins 2–3 blank ROM mode 1–2
JP5 must be installed on
JP6 maintenance – do not use off
JP7 ROM emulator – do not use off
JP8 Mylex manufacturing diagnostics – do not use off