Mylek MYC01-10A, Инструкция по эксплуатации

Страница: 6 / 15

www.mylek.co.uk
6 | Page
•
Securely fasten the hanging bracket to the wall with the screws provided. Make sure the
hanging bracket is in the correct direction. Image 3 on Figure 2 below.
•
Gently insert the bottom of the heater to the hanging bracket first and then push the top of
the heater body onto the hanging bracket. It is good practice to try attaching the hanging
bracket to the heater and taking off, so you are familiar with how it attaches and detaches.
•
When the heater is attached to the hanging bracket, secure into place by turning the two
plastic securing grips. Image 4 on Figure 2 below.
Warning:
Be sure to keep a distance around the heater of at least 15cm (150mm) see image below.
Warning! When drilling holes, always check to ensure there is no electrical wiring, gas pipes,
water pipes etc in the area to be drilled.
Image 1 Image 2 Image 3 Image 4
Figure 2
LCD Control Panel:
Power button: on /stand by
Increase button: press to increase temperature. Also used for setting forward the hour in
24 hour program setting.
Decrease button: press to decrease temperature. Also used for decreasing the hour in 24
hour program setting.
Select button for mode or program.
≥
150mm
EPC01-10A
EPC01-15A
EPC01-20A
≥ 150mm
≥ 150mm ≥ 150mm
≥ 150mm
K
MYC01