www.hsdonline.co.uk
CHARGER PROCEDURE
Recharging the batteries
A CHARGING THE INSTALLED
BATTERY: Do not use another battery
charger. When the battery is empty,
the machine is switched off by means
of a protective circuit : The chuck no
longer rotates. In a warm environment
or after heavy use, the battery pack
may become too hot. Allow time for
battery to cool down before
recharging.
B IMPORTANT NOTES CHARGING THE
BATTERY: The battery in your new
tool is not charged when it leaves the
plant. Therefore it must be charged
for 1 hour before using for the first
time!
1 When the battery charger adaptor is
plugged into the battery and the LED
light shows Red on the adaptor, the
battery is ready for charging. When
the battery LED light shows Green on
the adaptor, the battery is fully
charged and ready for use.
2 Do not leave the battery connected
to the charger for longer than 5
hours. Please remember this is a 3-5
hour charging unit.
WARNING: When battery
charge runs out after
continuously use or exposure
to direct sunlight or heat, allow
time for the battery to cool
down before recharging to
achieve the full charge
1
Removing/installing battery pack
2
To remove or install the
battery pack
1 Hold down the battery release
button.
2 Slide the battery out.
MY18VCB_18V_Drill_Manual 17/5/18 10:21 Page 8
