MYIRO myiro-9, Инструкция по эксплуатации

Страница: 30 / 44

Taking measurements
Feeding test charts when using the MYIRO-9 alone
• For information on feeding test charts when using the optional Auto Sheet Feeder FD-A09, please see below.
1
Place the end of the test chart on the Paper Guide with the
printed surface facing up, and slide the paper guides so that
they are positioned touching the sides of the test chart as
shown.
• For details on chart conditions, see p. 37.
2
Slide the test chart gently between the guides and into the MYIRO-9.
When the test chart enters the MYIRO-9 by a certain amount, it will be
automatically pulled into the MYIRO-9 for measurements. When the
MYIRO-9 starts pulling the test chart in, let go of the test chart.
• Be sure to slide the test chart in straight. If the paper guide positions are
too narrow or if the test chart goes in at an angle, the test chart may ride up
onto the paper guides, which may cause measurement accuracy to suffer.
Feeding test charts when using optional Auto Sheet Feeder FD-A09
1
When using the Auto Sheet Feeder, place the test charts in the
supply tray with the printed surface facing up and slide the
paper guides so that they are positioned touching the sides of
the test charts as shown.
Recommended maximum number of loaded sheets:
Normal paper (80 g/m 2 ): 100 sheets
Heavy paper (130 g/m 2 ): 70 sheets
Paper size:
Paper width: 90 to 320 mm
Paper length: 170 to 450 mm
Paper thickness: 0.08 to 0.25 mm
• For more details on chart conditions, see p. 37.
Feeding of the test charts from the supply tray into the MYIRO-9 is controlled by the software. For details, please refer to the software
instruction manual.
28