AUDIOPHILE MM /MC RIAA PREAMPLIFIER
Dear customer,
Thank you for purchasing a Micromega product. This unit provides ease of use
and sonics of the highest quality. Please pay close attention to this instruction
manual, and read it fully before attempting to operate. It is designed to ensure you
maximise your pleasure of listening to MyGROOV.
Checking
Check that the carton has no damage. Should you have any doubt about its condi-
tion, please do not hesitate to contact your dealer.
Opening the box, you should find:
• One C7 AC Mains cord matching your area.
Mains voltage
MyGROOV is equipped with an internal universal power supply allowing you to use
it with voltage and frequency in the range of 85-265 Vac / 50-60 Hz.
Connections and Power up
Except for the mains cord, MyGROOV is not supplied with any interconnect cables.
To get the best out of your unit, we recommend that you use good quality cables.
Check with your dealer. Following the diagram on the next page, connect your
turntable to MyGROOV inputs. Connect the stereo analog output of MyGROOV to
a line input of your amplifier. While doing this, we recommend you to have your
amplifier turned off. Do not forget to connect the Ground wire of your turntable to
the GND post of MyGROOV.
Plug the AC line cord to the mains input of MyGROOV and then connect the other
end to your wall mains inlet. As soon as MyGROOV is connected to the mains, the
led located under the MyGROOV logo will light up in red indicating that the unit is
in Standby mode.
Operation:
MyGROOV central wheel is used to get out of standby and to set up the input to
match your cartridge model MM or MC.
A Mute position between both inputs and a time delay of 3 seconds guarantees no
noise operation while changing inputs.
Standby
Turn the wheel to the extreme left position.
MyGROOV is then in standby mode and the led located under the MyGROOV logo
turns red. The unit is then respectful of the most stringent ECO regulations.
Cleaning of the unit
1. Unplug MyGROOV from AC mains.
2. Using a soft cloth, gently wipe out the dust from MyGROOV surfaces. To
avoid any damage to the product, never use any solvent or cleaning product
containing solvent such as acetone,trichloroethylene, ...Never use any abrasive
material to clean MyGROOV.
3. Once MyGROOV has been cleaned you can connect the unit to the AC
mains again.
Working conditions
Working temperature : from 0° to 35° C (32° to 95° F)
Storage temperature : from -25° to 60° C (-13° à 140° F)
Relative humidity (working) : from 20 % to 80 %
Relative humidity (storage) : from 10 % to 90 % (without condensation)
Warning
• Do not use MyGROOV near water.
• Do not place objects filled with liquid on or near MyGROOV.
• Do not place MyGROOV near any heat sources such as radiators, stoves or
other heat-generating products including open flames.
• Disconnect MyGROOV during lightning storms or when unused for extended
periods.
• Refer all service-related issues to qualified personnel.
L
R
L
R
85 - 265 V
50-60 Hz
AC MAINS
MADE IN FRANCE
Left
Right
Input
Left
Right
Output
GMD
Amplificateur intégré/
Integrated Amplifier
Platine/
Turntable
Notice MYGROOV 140x140 UK.indd 4-6
14/03/13 18:10