Myenergi ZAPPI-2H07TB-G, Руководство пользователя

Страница: 19 / 29

Page 19 of 29
relay is open to make sure that the
supply to the EV is isolated.
PEN Fault!
Fault code 29
The internal protection against
the loss of the PEN conductor on
the electricity supply has tripped.
Unplug the EV, make sure that the
fault has been removed then press
and hold the button to reset the
unit.
Overload !
Fault code 30
The EV is drawing too much
current – the output is switched
off.
Unplug the EV, press and hold the
button to reset the unit.
Bad Voltage Range !
Over Voltage!
Under Voltage!
Fault code 31
zappi
has detected that the
supply voltage is too high/low and
has disconnected the EV to
protect it.
Unplug the EV, make sure that the
fault has been removed and hold
the button to reset the unit.
Overheating! The
zappi
unit is too hot – the
output is switched off.
Make sure that the
zappi
is
properly ventilated (e.g. has not
been covered).
Charge will resume once the unit
has cooled down again.
Voltage Mismatch !
Fault code 32
The output voltage detected by
zappi
and the built-in protection
components is not the same.
Unplug the EV, press and hold the
button to reset the unit
Charge Blocked !
zappi
has detected that the EV
has repeatedly tried to start a
charge even though the EV has
previously reached “Charge
Complete” i.e. The battery is full,
the battery has reached a charge
level set in the EV, or the charge
has been stopped by a timer in the
EV.
Unplug the EV
Charging will continue when the
EV is plugged in again
If any of the above faults persist then stop using
zappi
and contact your supplier or
myenergi
Technical
Support.
14. Warranty
Full details of the
myenergi
product warranty are available on our web site or by using this QR code.