mychway 1005894, Руководство пользователя, Страница: 22 / 35

supply of the device is turned off before the staff leaves after daily use, so as to
ensure the safety of the electrical products.
9. Use device or train device operators in strict accordance with instructions in the
user manual.
10. Start from the lowest energy level and slowly add up.
11. When using this device, the operating parts must be kept moist and dry skin
should be avoided.
12. Please refrain from operating around eyes, ears, skin lesion or parts that had
undergone plastic surgery.
13. Adjust the suction level based on the customer’s feedback during hydro
dermabrasion treatment.
14. Do not place the probe at one spot for over 5 seconds to avoid scald or frostbite.
15. Hydro dermabrasion, RF and micro current handpieces can be used alone or
together for better results.
16. Clean the instrument with normal saline after operation to ensure its cleanliness
and hygiene to prolong its service life.
17. Inform the customer in advance of the expected experience during micro current
treatment to avoid any unexpected result.
18. All hydro dermabrasion tips of hydro facial can be cleaned with water and soaked
in 75% alcohol.
19. Please clean the waste bottle immediately after the hydro dermabrasion
treatment.
20. Tip Cleaning: Always clean the tips to prevent infection. Use disposable
toothbrush to clean away gunks hidden inside the grooves, then soak in alcohol for 3
minutes and lastly rinse it off.
21. Twist the bottle tight onto the device, otherwise the internal leakage will reduce
the air pressure, resulting in no suction or too little water.
22. Internal cleaning (clean each bottle of solution after use):
Replace the probe with a cleaning head, fill the solution bottle with half a bottle of
water, turn on the device, cover the probe by hand, adjust the water flow to the
maximum and let the water flow back automatically to clean the residual solution in
the pipe for about 1 minute.
4. Troubleshooting & Solutions
1. The instrument can't start and the key lamp on the back of the instrument doesn't
work?
A. Ensure that the power cord is connected to a working power outlet.
B. Ensure the fuse tube on the back of the instrument is not loose or being burnt.
2. No RF output of the instrument?
A. Please check whether the plug connecting the instrument handle and the body is
tightly connected.