myBilding Formax FD 8902, Инструкция по эксплуатации

Страница: 12 / 27

8
Operation Operation
1. Set main switch to ON (page 7). Turn the Key OFF/ON toggle switch on the control panel to the ON position.
2. Press the START button. The conveyor will begin to move in the forward direction.
3. Place the material to be shredded on the feed table, then slide it onto the infeed conveyor belt, in
appropriate stacks. (Up to 650 sheets.)
NOTE: If material is accidentally placed onto the conveyor belt, DO NOT REACH FOR IT. Instead, press the
red STOP button (left side of control panel) or the Safety Stop Bar (front of feed table). When the shredder
stops, press and hold the REVERSE button. The conveyor will operate in reverse, allowing safer access to the
materials. The shredder will stop when the REVERSE button is released. To resume shredding, press STOP
button, then the START button.
Turning off the shredder
1. To shut down the shredder, press the STOP button on the control panel.
2. Turn Key OFF/ON toggle switch on the control panel to the OFF position (to the left).
3. Open the electrical control panel door, and fl ip the main power switch DOWN to the off position.
Overloading the motor
If the shred capacity of the machine is exceeded (too large a stack of paper, etc), the shredder will stop
automatically. To resume shredding:
1. Push and hold the REVERSE button until the paper or other material backs completely out of the shredder.
2. Press the red STOP button or the SAFETY BAR on the front of the machine, then divide the materials into
smaller stacks.
3. Press the START button. The conveyor and cutting blades will begin to move.
4. Continue shredding, feeding less paper or fewer materials at a time.
Frequent Overloading
If the shredder is repeatedly overloaded, the motor can overheat, which will cause the shredder to switch off
automatically. To resume shredding:
1. Allow the motor to cool down for approximately 20 - 30 minutes before using.
2. Once the motor has cooled suffi ciently, resume shredding by following standard operating procedure.
NOTE:
To maintain optimum performance and allow constant operation, avoid repeatedly
overloading the shredder. This will prevent time-consuming reversing cycles, and will
provide the highest possible throughput.
Oiling Cutting Blades with semiautomatic EvenFlow Oiling System
To keep the cutting blades in peak operating condition, Formax recommends using the EvenFlow Oiler prior to
the initial use, large shredding jobs, or whenever shred capacity appears to be decreased.
1. Open yellow screw-top cap on external pump assembly (see page 19). Fill with Formax 8902 shredder oil.
Do not fi ll above top red line on pump window. Replace cap.
2. To operate, pump the handle two to three times.