Figure: 2
Figure: 3
Installer is responsible to check local codes
and read all instructions prior to installation.
Layout designed in U.S.A. © 2022
NOTE: Diagrams and Illustrations NOT to Scale
Page 2 of 4
MyFireplaceBlower.com
Step 2: Removing Upper & Lower Louvers for access
to install Blower and Power Cord with Cord Set.
See (Figure: 2) for illustration of “Fin” or “Slit”
Louver types. Typically, screws are securing the
Louvers in place.
•A “Cross Member” or “Hood” may need to be
removed also (Figure: 2).
•Pull Louver Assembly straight out from fireplace.
My Fireplace Blower LLC
Burlington, Wisconsin
1-800-466-4045
Step 3: Removing Valve Cover Shield
•Open bottom Louver Assembly by swinging the
assembly down (Figure 3).
•Using short Phillips screwdriver, remove screw
under center of Cross Member if necessary.
Rotate Valve Cover Shield clockwise and slide out
(Figure 3 - #1).
•IMPORTANT: Do not remove Side Screw on left side
of Valve Cover Shield. Slide Valve Cover Shield off
Side Screw (Figure 3 - #2).
where you purchased this kit or DESA International at 1-800-972-
Upper Louver
Assembly
Blower Bracket
Mounting Holes
Hood and Upper Louver with “Slit” Formations
Hood
Cross Member and Upper Louver “Fin” Assembly
Blower Bracket
Mounting Holes
Upper Louver
Assembly
Cross Member
WARNING: Never attempt to service Fireplace
while it is plugged in, operating, or hot. Burns
and electrical shock could result.
Bottom Louver
Panel
Side
Screw Valve Cover
Shield
Side
Screw
Removing Valve Cover Shield
Firebox
Frame Support
Ring
Bushings
