MX Options Concentric, Инструкция по монтажу

Страница: 9 / 16

11. FITTING THE VERTICAL RAIL AND HANDSET
1. Establish position for the riser rail, and mark
the wall for the lower mounting bracket. Make
allowances for the tallest person likely to use the
shower regularly (Fig 1).
2. Remove covers from the wall brackets (Fig 2).
3. Position the lower bracket and mark the wall for
the screw fixing. Then drill and plug the wall and
fix the lower bracket without the rail location notch
(Fig 3).
4. Fit the rail into the lower bracket. Place the
remaining bracket with the rail location notch
on top of the rail, making sure that the rail slot is
located into the notch. Ensure the hole position is
vertically aligned and mark the wall. Remove the
rail and bracket, then drill and plug the wall.
5. Slide the height adjuster onto the rail. Tighten to
the rail by turning the locking cap. Then fit the
soap dish, dampening the rail will make it easier to
slide on. Finally fit the hose retaining ring onto the
bottom of the rail below the soap dish (Fig 4).
6. Replace the rail assembly into the lower bracket.
Refit the top bracket, ensuring the slot in the rail is
located into the bracket notch and fix to the wall.
7. Slide covers onto both brackets.
8. Firmly attach flexible hose to showerhead making
sure sealing washer is in place after first passing
through the hose retaining ring (Fig 5).
5
12. OPERATION
TO CONTROL THE FLOW
Slide the lower handle to the left, anti-clockwise,
to turn on and increase the flow. Slide to the left,
clockwise to decrease and turn off.
TO CONTROL THE TEMPERATURE
Turn the centre handle anti-clockwise, for hot and
clockwise for cold.
• Temperature Control
Flow Control •
4
3
1
2
NOTE: It is the conical end of the double interlock
hose which grips into the handset height adjuster.
The handset will not fit in the height adjuster
without the double interlock hose attached.