11.
Switch of pull-cord or wall mounted
switch.
2
PACK
CONTENTS
1
10
SECTION
OPERATING THE
SHOWER
1.
Switch on pull-cord or wall mounted
switch. The
‘Power’
neon will illuminate
indicating the switch is on.
2.
3.
Select your power setting using the top
control. The shower has two positions
‘Low’
power and
‘High’
power.
‘Low’
setting
.
Turn the top power selector knob to the
LOW
(Single
Large
Solid Red Dot - Sited
at the 9 o’clock position)
setting, this
action will also activate the internal solenoid
valve turning the water On.
(Single
Larger
Solid Red Dot
- Sited at the 9 o’clock position)
This is the low power setting for
economy during warmer months or
when a cool shower is required.
Temperature adjustment is via the
bottom temperature control.
‘High’
setting
(Double Solid Red Dot)
:
This is the full power setting.
Temperature adjustment is via the
bottom temperature control.
4.
Wait a few seconds for the warmer
water to reach the handset.
5.
If necessary turn bottom
‘Temperature’
control knob slowly to obtain desired
showering temperature. Again, waiting a
few seconds after each adjustment in
temperature to reach the handset.
Note:
To adjust the shower temperature.
The water temperature is altered by
increasing or decreasing the flow rate
of water through the shower unit via
the temperature control.
To increase the shower temperature
Turn the temperature control knob
clockwise, this will decrease the flow
of water and increase the shower
temperature.
To decrease the shower temperature
Turn the temperature control knob
anti-clockwise, this will increase the
flow of water and decrease the shower
temperature.
6.
Turn the top power selector knob to the
STOP
position to stop the flow.
7.
A small amount of water will be retained
in the showerhead after the shower has
been turned off. This may drain over a few
minutes.
8.
Switch Off pull-cord or wall mounted
switch.
2
PACK
CONTENTS
1
11
SECTION
OPERATING FEATURES
LOW
STOP
HIGH
WARMER
COOLER
Power Neon Indicator
The ‘Power’ neon indicator will be
illuminated when the shower unit is
switched on and water is flowing on the
heat settings.
I
2
PACK
CONTENTS
1
12
SECTION
SHOWRHEAD CLEANING
INSTRUCTIONS
The showerhead should be cleaned
periodically to remove limescale or debris
which will reduce the performance of the
shower. The frequency of cleaning will vary
according to local water quality.
PERIODICAL MAINTENANCE
3.
If scale deposits are stubborn,
soak the showerhead in a
proprietary limescale remover
and rinse thoroughly before use.
2.
Some showerheads are fitted
with self clean probes, to help
the removal of limescale. These
probes can be activated by
rotating the lever clockwise.
1.
To break away scale deposits
on a daily basis simply rub your
thumb over the surface whilst
the shower is running.