MX Atmos Zone, Инструкция по монтажу

Страница: 9 / 16

10. FITTING THE WALL ARM FITTING
1. Establish position of wall arm to suit users
requirements (Fig 7).
2. When fitting the wall arm drill a 19mm hole
through the wall, you may require a suitable piece
of wood to give the arm support behind the tiles or
plasterboard.
3. Remove fittings and nut from end of arm through
wall, re-fit washer and nut.
4. Connect wall arm to the pipework installed from
the valve.
5. When attaching the fixed showerhead make sure
the sealing washer is in place and screw tight to
seal the joint, again a flow controller can be fitted if
required (Fig 8).
6. Water pressure test to make sure there are no
leaks before tiling. See note Section 8-9.
NOTE: The fitting of these items should be carried out
by a competent person.
7
8