Mx Onda MX-PM2778, Инструкция по эксплуатации

Страница: 19 / 42

5
BEFORE USING THE POPCORN MAKER FOR THE FIRST TIME
•
Read all sections of this manual.
•
Remove the lid with measured for corn kernels 4 , and remove the top cover
1 by pulling it upwards.
•
Wash with soapy water the lid with measured 4 , DO NOT use abrasive
cleaners or scouring liquid, then dry with a cloth
•
The top cover 1 , the main body 3 and the container for the corn kernels 6
have been cleaned with a damp cloth. DO NOT use scouring pads, alcohol,
solvents, gasoline or abrasive liquids, then carefully dry all surfaces with a
soft cloth.
•
Replace the top cover above the main body and the lid with measured for
corn kernels again.
USE OF POPCORN MAKER
1.
Make sure the top cover is properly attached to the main body, otherwise it
may fall, splashing the room with popcorn when they were getting.
2. Insert the plug of the power cord into an electrical outlet of 230 V, provided
ground.
3. Completely fill (to the brim) the lid with measured for corn kernels 4 and
insert through the hole feeder 5 .
VERY IMPORTANT: Never add less or more grains of corn than will fit in
the metering pan. If you add less quantity, can many kernels of corn are
not made and if you add more quantity than can fit in the dosing pot,
popcorn can burn and smoke comes out of the machine because more
popcorn which I do fit in the container.
4. After dumping the corn kernels into the container to the corn kernels 6 ,
replace the lid with measured for corn kernels 4 in its housing, thus can
prevent out popcorn at the bore-feeder 5 .
5. Place a bowl or similar container under the opening mouth 2 . The bowl or
container must be high to match the ramp of the outlet to avoid the popcorn
once made go to bowl or container.
6. Press the switch on / off 7 and the hot air generator will start and in a
minute start to come popcorn.
When you see that all the corn kernels have fully popped turn off the pop
maker pressing switch
7 .
7. If necessary can tilt forward the popcorn machine to make sure there are
no popcorn inside the container.
8. Serve popcorn to your liking, just how out of the machine and add salt,
pepper, sugar, candy, etc.
9. Before returning to prepare popcorn, you should allow at least 15 minutes
for the hot air generator cool. Also you should check for any remaining corn
kernels or popcorn inside the container
6 .