
H.264MP-PTZ RTSP Streaming User’s Manual
8
Chapter 3
Cable and Connectors
3.1 Tail Wire Connectors
1. Terminal (A+/ B-) : RS-485 A+/ B-; D+/ D- to control PTZ
2. Reset Button : Restore to factory default settings (short the two terminal at power on)
3. Connector : Female audio output / earphone
4. Power connector : DC12V output
5. Connector: Female audio input port to sound monitor/ microphone.
6.
Terminals (Alarm) : Alarm input (NC or NO) /
Alarm output (on/off output, 220VAC 1A/ 24VDC 1A)
7.
RJ-45 : Network Ethernet connector, LEDs flashing when accessing
Note:
After “
Reset
” Please must notice you must set your computer IP to 192.168.55.xxx, for example
192.168.55.20 so that you can connect the camera after reset (restore to factory default IP
192.168.55.160), must remember to disable wireless adapter or set wireless IP to different subnet (from
wired IP), before performing other necessary settings.
WARNING: Unpacking
Please must ask user to remove cushion inside dome bubble, clear warning
messages on top of dome bubble (also in user's manual) indicates don't
power
on before remove all cushion, or may damage the camera.