Mweld WAVE 200DIII, Руководство пользователя, Страница: 6 / 25

6
-Do not look into the valve when opening it.
-Use protective cylinder cap whenever possible
1.5 Proper Care, Maintenance and Repair
EMBED Word.Picture.8
-Always have power disconnected when working on internal components.
- Do not touch or handle PC board without being properly grounded with a wrist strap. Put PC board in static
proof bag to move or ship.
-Do not put hands or fingers near moving parts such as drive rolls of fan
WAVE 200D
III
USE AND CARE
Do not modify the WAVE 200D
III
in any way. Unauthorized modification may impair the function and/or
safety and could affect the life of the equipment. There are specific applications for which the WAVE 200D
III

was designed.
Always check of damaged or worn out parts before using the WAVE 200D
III
. Broken parts will affect the
WAVE 200DIII operation. Replace or repair damaged or worn parts immediately.
Store idle WAVE 200DIII. When WAVE 200D
III
is not in use, store it in a secure place out of the reach of
children. Inspect it for good working condition prior to storage and before r
e-use.
Notice: * If the welder continues to work too long time, the
【
Protection Indicator
】
on the panel
would be on, indicating that the inner temperature rise inside the welder had exceed the
designed permitted temperature. At this time, stop the welding work, wait until the welder cooled inside
and the
【
Protection Indicator
】
turned off, then continue to work again;
* Cut off the power switch and Argon valve, before leaving the welding place temporarily or after the
welding worked finished;
* Welders should wear canvas work clothes and welding face shield to prevent arc light and heat
radiation;
* Put light-proof screen around the work area to prevent others influenced by the arc lights.
* Flammable, explosive items could not be put near the welding area;
* Every outlet of the welder should be connected and earthed correctly.
Notice: The cover protection degree of the WAVE series Square Wave AC/DC pulsed inverter
TIG welder is IP21S.When the welder is operated, do not insert finger or round stick diameter less than
12.5mm (especially metal stick) into the welder; Do not allow to press heavily onto the welder.