20 / 21
BETA series
Model:
BETA 12K WIFI
BETA-user manual-EN-R1 27.07.2020
•
Press OPTION again to activate the 8°CH function, and 8°CH
appears on the display.
Do it again to deactivate this function.
If the air conditioner is standby, this function enable the air conditioner
automatically start heating when the indoor temperature is equal or lower
than 8°C, it will return standby if the temperature is equal or higher than
18°C.
9.
T
ROUBLESHOOTING
9.1.
P
OSSIBLE FAULTS
CASE
POSSIBLE CAUSE
Device doesn't work
A power failure / defective plug has occurred
Indoor / outdoor unit fan motor damaged
Compressor thermomagnetic switch defective
Defective protective device or fuses
Too loose connections or plug
Automatic off device, self-protection function
Higher or higher voltage than recommended
TIMER ON function active
Motherboard damage
Strange smell
The air filter is dirty
Sound of flowing water
Regression liquid in the drain
A slight mist is emitted from the
air outlet
This happens when the air in time becomes very cold,
for example in COOL or DRY modes
Strange noise
This noise is caused by expansion or contraction of the front panel due to temperature
changes, not a problem
Insufficient air flow, too hot or
cold
Incorrect temperature setting
The air inlet or outlet of the indoor or outdoor unit is blocked
The air filter is blocked
The fan speed is set to the minimum
Other heat sources in the room
No refrigerant
The device does not respond to
commands
The remote control is not close enough to the indoor unit
Low battery on the remote control
There is an obstacle between the remote control and the signal receiver on the main unit
Display is off
LED function active
No power
