MVP HVLS-1000, Руководство по эксплуатации

Страница: 16 / 59

HV Series Fluid Section Operations Manual
Page | 16
DANGER
Contaminated catalyst may cause fire or explosion. Never use any
lubrication on the components of the catalyst system. Contact your
catalyst manufacturer for additional material handling information.
Requirements
Air Requirement
Clean, dry compressed air must be available at up to 90 psi (6 bar) and a minimum volume of 14
CFM. Air must be provided through an air hose with a diameter of .5 inches (1.3 cm) or greater.
Tools and Supplies
When performing service or repair on the fluid section, you should have the following available:
 TABLE VISE
 PISTON BODY WRENCH
 CLAMSHELLS (PACKING REMOVAL; SET OF 2)
 REMOVABLE LOCTITE™ 243 OR EQUIVALENT THREAD LOCK COMPOUND
 SMALL HAMMER
 NEEDLE-NOSE PLIERS
 SOLVENT OR EMULSIFIER FOR CLEANING
 CLEAN WORK TABLE
 SET OF HEX WRENCHES
 5/8-INCH WRENCH
 9/16-INCH WRENCH
 5/16-INCH WRENCH
 EMPTY BUCKETS FOR CLEANING
 CLEAN ¼-INCH PLASTIC DOWEL OR ROD
 8-INCH ADJUSTABLE WRENCH
 12-INCH ADJUSTABLE WRENCH
 7/16-INCH OPEN END WRENCH
 WOODEN STICKS OR TONGUE DEPRESSORS (FOR TESTING)
 LABELS AND PENS FOR MARKING PNEUMATIC LINES
 CLEAN RAGS AND PAINT BRUSHES FOR CLEANING
 TUBE OF MEDIUM-WEIGHT LITHIUM GREASE
 LARGE (APPROX. 3 FT BY 10 FT (1 METER BY 3 METERS) STRIPS OF PAPER FOR
PERFORMING SPRAY TESTS
 PIN WRENCH (COMES WITH CATALYST JUG)

SCRIBE
 RED GREASE
 SEAL KIT FOR YOUR MODEL
Note Lubriplate® is a registered trademark of the Lubriplate division of Fiske
Brothers Refining Company.
Note Loctite TM is a trademark of the Loctite Corporation.