t r o u b l e s h o o t i n g
In the event of a problem with your MCD-1000, use the following troubleshooting chart to remedy or isolate the
cause. If you are unable to remedy the problem, see
Important Telephone Numbers
on page 16 to call your local
Affiliate or Muzak Customer Service.
S Y M P T O M / P R O B L E M
P O S S I B L E C A U S E / S O L U T I O N
No power
AC cord loose or not plugged in
Blown fuse
See section below
Disc doesn't play
No CD in tray
Consumer audio disc
Not compatible with this system
Jammed CD
CD loaded upside down, dirty or damaged CD, or defective CD player
Low or no volume
Speaker wire disconnected or Volume control off
Mismatched output connection
See page 15
Blinking LEDs
• Power & Shuffle
Incompatible consumer audio CD. Load Muzak CD
• Play
Fail to initialize disc, damaged disc or malfunctioning player
• Power & Shuffle
Fail to play music, damaged disc or malfunctioning player
• Power & Play
Disc tray failure. See next page:
REMOVING A JAMMED CD
w h a t y o u s h o u l d d o
F U S E R E P L A C E M E N T P R O C E D U R E
1.
Remove the AC power cord from the AC inlet on the rear panel.
2.
The fuse holder is in a small compartment directly beside the AC power cord.
3.
Pry the fuse holder open with your fingernail or small flat blade screwdriver.
4.
Remove the blown fuse and replace it with a spare. This fuse is referred to as a GMA or 5x20 mm type fuse.
Additional fuses may be obtained from your local Muzak Affiliate, or from your local Radio Shack store
(part # 270-1051).
CAUTION
— DO NOT USE SLO-BLO OR TIME DELAY FUSES.
CONTINUED
14
